Articles for "Twain Capture" Tag

Vatech Sensor unable to aquire images into Dexis when bridge from Dentrix; when the workflow starts in Dentrix due to a “missing” driver.  Dentrix chart is opened, a bridge is initiated to open Dexis  EzSensor does not work. If Dexis is opened stand alone, the EzSensor will work normally. \Verify the Sensor is insta...

When acquiring IOX images with Jazz Sensors to EzDent-i the images might be rotated incorrectly.

To setup the TWAIN Capture please reach out to Archy Support  Open Clinical  Imaging Select 'Settings' on the left hand side Navigate down the list to 'Imaging Profiles'   In order to set the rotations globally for the EzSensor in all templates, run through the Mount Preferences Setup under Setup Helpers:   F...

After installing Vatech Intra Oral X-ray device, the "Intraoral USB Sensor" TWAIN device to show up in VixWin's list of TWAIN sources

DentiMax Dream IOX TWAIN - AutoAdvance  DentiMax TWAIN Driver UI has a tray icon where it can be configured for single shot or multi-shot.DentiMax Sensor Image Quality Configurations   DentiMax has a config.ini file with image preprocessing values that can be configured located in : C:\ProgramData\DentiMax\ Customer should call ...

Open C:\Program Files (x86)\VATECH\EzDent-i\Setting Open the Twainconfig.ini Edit the USE_Twain20_DLL = ON or OFF  ON : Normally used for NEWER TWAIN source drivers OFF: Normally used for OLDER TWAIN source drivers

To configure DEXIS TWAIN you will either need to have purchased the DEXIS imaging for Version 9 or have already upgraded to DEXIS Version 10 or higher. The following guide is based on Version 10+ Note: For IOS - Sensors - Autoadvance TWAIN functions; you must have Dexis Version 10 or higher* using the Advanced - AutoAdvance Twain.   ...

There are three places in SOTA Cloud whereas additional enhancements gets applied causing over-sharpening, which could be described as noise / static / graininess Verify the image quality is normal using Twack32 Twain Test tool Filter Tuner (System Tray Icon) - Right Click with the SOTA Cloud system tray icon.  Seclect "Filter Turner&q...

First, make sure ALL twain settings are correct: Correct patientinfo.ini path and info Linkinfo.ini has the correct paths VATWAIN is configured properly (if used)Environment.ini and environment_twain.ini (if used)Second, test using TwackerTo set up twain to work within Tracker, you must select the Twain Device CMD option when trying to acquire. To ...

Dexis support multiple capture types; Intraoral as well as Ceph/Pano. Some cases if calling the scanner /Twain function of dexis from the I/O section (Noted in the software by a tooth icon) and separated by 1 to 4 lines the image will often time result as being chopped up into I/O sized images.To avoid this issue; the icon resembling the upper huma...